Ranger 2WD V6-4.0L (2010)
Shifter M/T: Service and Repair
Gearshift Lever and Boot
NOTE: Without FX4 option shown, FX4 similar.
Removal and Installation
Vehicles with FX4
1. Loosen gearshift knob jamb nut and turn the knob counterclockwise until the knob is removed.
Vehicles without FX4
2. Remove the gearshift knob by pulling the knob upward.
All vehicles
3. Raise the outer gearshift lever boot and console assembly to access the nut and eccentric stud that retains the upper gearshift lever to the lower
gearshift lever.
1. Remove the 2 screws retaining the console to the floor.
