Ranger 4WD L4-122 2.0L SOHC (1984)
Locknut Washer
7. Remove locknut washer from spindle.
8. Tighten the inner locknut to 47 Nm (35 ft lb) while turning the rotor in the opposite direction to seat bearings.
9. Spin the rotor and back off the inner locknut one-quarter turn. Retighten the inner locknut to 1.8 Nm (16 in lb).
10. Install the lockwasher on the spindle.
11. Install the outer wheel bearing locknut using locknut wrench. Tighten locknut to 203 Nm (150 ft lb).
12. Check the end play of the wheel and tire assembly on the spindle. Final end play should be 0.02-0.08 mm (0.001-0.003 inch).
13. Install the axle shaft spacer.
14. Clip the snap ring onto the end of the spindle shaft.
15. Install the manual hub assembly over the spindle. Install the retainer washers.
16. Install the wheel and tire assembly. Install and tighten lugnuts to 135 Nm (100 ft lb).
