Ranger 4WD L4-134 2.2L DSL (1983)
Brake Shoe: Service and Repair
Removal
For additional information see Notes, Warnings, and Hints.
Brake Components - 10 Inch Drum
1. Remove the wheel and drum.
2. Inspect brake cylinder for signs of leaks or presence of rust by removing the boots and inspecting interior surfaces.
NOTICE: Water leaking into the cylinder past the boots will cause rust to form and may cause the cylinder to seize. If the boots are not removed,
brake fluid leakage past the cups may go undetected because the boots may seal the fluid in the cylinder. If leaks are found, the brake cylinders
must be removed and repaired or replaced.
Compressing The Brake Cylinder
3. If no leaks are found, install a brake cylinder clamp over the ends of the cylinder as shown.
4. Contract the shoes as follows:
a. Disengage the adjusting lever from the adjusting screw by pulling backward on the adjusting lever cable.
b. Shorten the length of the adjuster by screwing the threaded rod in. This is done by moving the outward side of the adjusting screw upward until
the pivot nut is backed off as far as it will go.
