Ranger 4WD L4-140 2.3L SOHC (1984)
Compressing Pin Tabs
7. Use needle nose pliers to compress the outboard end of the pin while prying at the same time with the screwdriver, until tabs slip into the spindle
groove.
8. Place one end of a punch (approximately 7/16 inch diameter) against the end of the caliper pin and drive the caliper pin out of the caliper slide
groove.
9. Repeat removal procedure for lower pin.
10. Remove the caliper from the rotor. If the caliper is to be removed for service, disconnect the brake hose from the caliper. If not, secure the caliper
with wire.
CAUTION: Do not let the caliper hang with its weight on the brake hose.
11. Compress the anti-rattle clip and remove the inner pad from the caliper.
