Ranger 4WD L4-140 2.3L VIN A EFI (1997)
Clutch Pedal Assembly: Service and Repair
REMOVAL
1. Disconnect the clutch master cylinder push rod by prying the retainer bushing and push rod off pedal pin.
2. Remove left side plastic cowl side panel.
3. Remove bolts securing parking brake mechanism. Swing mechanism out of the way.
4. Remove the retainer ring.
5. Remove the clutch pedal from pedal support bracket.
NOTE: When the clutch pedal shaft is removed from the bracket, the brake pedal, brake and clutch pedal bushings and spring washer become
accessible.
INSTALLATION
1. Install clutch pedal shaft through clutch and brake pedal support, brake and clutch pedal bushings, brake pedal and washers (as shown).
NOTE: Before installation of the clutch pedal shaft or clutch pedal, remove and inspect the brake and clutch pedal bushings, clean and lubricate
with a light film of SAE 30 engine oil or equivalent and replace the brake and clutch pedal bushings if excessive wear is evident.
2. Install retainer ring.
3. Install clutch master cylinder push rod to pedal pin.
4. Secure parking brake mechanism.
5. Attach left side plastic kick panel.
