Ranger 4WD L4-153 2.5L SOHC VIN C SFI (2001)
Oil Pressure Sender: Service and Repair
Oil Pressure Sender
Removal
1. Disconnect the battery ground cable.
2. NOTE: The intake manifold is shown removed for clarity.
Disconnect the wire connector at the sender.
3. Remove the oil pressure sensor.
Installation
1. NOTE: Apply Pipe Sealant with Teflon D8AZ-19554-A or equivalent meeting Ford specification WSK-M2G350-A2 to sender threads.
Tighten the oil pressure sensor.
Follow the removal procedure in reverse order.
