Ranger 4WD L4-153 2.5L SOHC VIN C SFI (2001)
2. Remove the utility tray.
1
Unscrew the two retainers.
2
Remove the utility tray.
3. Remove the restraints control module (RCM).
1
Slide and disengage the RCM electrical connector locking clip.
2
Release the tab and disconnect the RCM.
3
Remove the bolts.
4
Remove the RCM.
INSTALLATION
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS, CAUTIONS AND
NOTES AT THE BEGINNING OF THE REMOVAL PROCEDURE.
1. Install the RCM.
1
Position the RCM.
2
Install the bolts.
3
Connect the RCM electrical connector.
4
Slide and engage the RCM electrical connector locking tab.
WARNING: THE TIGHTENING TORQUE OF THE AIR BAG RESTRAINTS CONTROL MODULE (RCM) BRACKET
RETAINING BOLTS IS CRITICAL FOR CORRECT SYSTEM OPERATION.
2. Connect the battery ground cable.
3. With the restraint system diagnostic tools installed at all deployable devices, prove out the supplemental restraint system (SRS).
4. Disconnect the battery ground cable and wait at least one minute.
