Ranger 4WD L4-153 2.5L SOHC VIN C SFI (2001)
Wiring Harness: Service and Repair
Internal Harness Service
Removal
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
3. Disconnect vehicle harness from transmission case (16-pin) connector.
4. Remove the transmission pan.
5. NOTE: The main control assembly does not need to be removed.
Remove the transmission fluid filter.
1. Remove the screw.
2. Remove the transmission fluid filter.
6. Remove main control valve body wire loom.
^
Carefully lift up on wire loom guide and protector and disengage the retaining pins from the solenoid clamps.
7. Disconnect the solenoid electrical connectors.
1. Disconnect the shift solenoids and the CCS electrical connectors.
2. Disconnect the torque converter clutch (TCC) solenoid electrical connector.
3. Disconnect the electronic pressure control (EBC) solenoid electrical connector.
