Ranger 4WD L4-153 2.5L SOHC VIN C SFI (2001)
10. Install the special tool.
1. Position the special tool.
2. Install the bearing caps.
3. Install the bolts.
11. CAUTION: Use only flat, clean drive pinion bearing adjustment shims.
CAUTION: Selection of too thick a shim results in a deep tooth contact at final assembly. Do not attempt to force the shim between the special
tools. A slight drag indicates correct shim selection.
Use a drive pinion bearing adjustment shim as a gauge for shim selection.
^
After determining the correct shim thickness, remove the special tools.
12. Position the correct thickness drive pinion bearing adjustment shim and the pinion bearing on the drive pinion. Using a suitable press and the
special tools, press the pinion bearing until it seats firmly on the pinion.
13. Place a new drive pinion collapsible spacer on the pinion shaft against the pinion stem shoulder.
