Ranger 4WD L4-2.3L VIN D (2002)
10. NOTICE: Only hand-tighten the 6 mm x 18 mm bolt or damage to the front cover can occur.
Using the 6 mm x 18 mm bolt, check the position of the crankshaft pulley.
-
If it is not possible to install the bolt, the engine valve timing must be corrected by repeating this procedure.
11. Install the special tool to check the position of the camshafts.
-
If it is not possible to install the special tool, the engine valve timing must be corrected by repeating this procedure.
12. Remove the special tool.
13. Remove the 6 mm x 18 mm bolt.
14. Remove the special tool.
