Ranger 4WD L4-2.3L VIN D (2002)
Ignition Cable: Service and Repair
REMOVAL
CAUTION: Do not pull on the spark plug wire as it may separate from the spark plug wire connector inside the spark plug wire boot.
1. Remove the spark plug wire by slightly twisting while pulling upwards.
2. Remove the spark plug wire by slightly twisting while pulling upwards.
3. Disconnect the spark plug wire if routed through another spark plug wire.
INSTALLATION
1. To install, reverse the removal procedure.
^
Apply silicone dielectric compound to the inside of the spark plug wire boots.
NOTE: Wipe the spark plug wire sets with a clean, damp cloth before inspecting them. Without removing the spark plug wire sets from the spark
plugs or ignition coils inspect them for visible damage such as cuts, pinches, or cracked or torn boots.