Ranger 4WD L4-2.3L VIN D (2002)
Wheel Speed Sensor: Service and Repair
Sensor, Rear
Sensor - Rear
Removal and Installation
1. Raise and support vehicle.
2. NOTE: Clean off dirt and foreign material that may have collected around the rear anti-lock brake sensor before removal.
Remove the rear anti-lock brake sensor.
1. Disconnect the rear anti-lock brake sensor electrical connector.
2. Remove the bolt.
3. Remove the rear anti-lock brake sensor.
3. NOTE: Thoroughly clean the mounting surface.
NOTE: Inspect the anti-lock brake sensor O-ring for damage; lightly lubricate the O-ring with SAE 75W-140 High Performance Rear Axle
Lubricant F1TZ-19580-B or equivalent meeting Ford specification WSL-M2C192-A.
To install, reverse the removal procedure.