Ranger 4WD L4-2.3L VIN D (2002)
Install the nuts.
11. Install the lines and tighten the nut.
12. CAUTION: Do not allow the intermediate shaft to rotate while it is disconnected from the steering gear or damage to the clockspring can result.
If there is evidence that the intermediate shaft has rotated, the clockspring must be removed and recentered.
Connect the intermediate shaft to the steering gear input shaft. Install a new lower steering column pinch bolt.
13. Install the power steering fluid cooler.
14. Install the front stabilizer bar.
^
Orientate the front stabilizer bar as noted during removal.
15. Install the LH tie-rod end on the front wheel spindle tie-rod.
^
Rotate the tie-rod end the number of turns recorded during removal.