Ranger 4WD L4-2.3L VIN D (2002)
1. Position the Torsion Bar Tool.
2. Tighten the Torsion Bar Tool until the torsion bar adjuster lifts off of the adjustment bolt.
5. CAUTION: The torsion bar adjustment bolt is coated with dry adhesive, and must be installed new if it is backed off or removed. Failure to do so
can cause the adjustment bolt to loosen up during operation and a loss of vehicle alignment.
Remove the torsion bar adjustment bolt and the nut.
6. Loosen the torsion bar adjustment tool until all of the tension is removed from the torsion bar.
7. Remove the torsion bar.
1. Mark the torsion bar and the adjuster for correct installation.
2. Remove the torsion bar insulator.
3. Grasp the torsion bar and pull it free from the front suspension lower arm.
Installation
