Ranger 4WD L4-2.3L VIN D (2002)
1. Position the torsion bar into the front suspension lower arm.
2. Install the torsion bar adjuster.
1. Align the marks on the torsion bar and the torsion bar adjuster, then install the torsion bar adjuster.
2. Position the torsion bar insulator.
3. CAUTION: The torsion bar adjustment bolt is coated with dry adhesive, and must be installed new if it is backed off or removed. Failure to do so
can cause the adjustment bolt to loosen up during operation and a loss of vehicle alignment.
Preload the torsion bar.
1. Install the Torsion Bar Tool.
2. Tighten the Torsion Bar Tool until the new adjustment bolt and nut can be installed.
3. Turn the adjustment bolt until the preliminary adjustment measurement is reached.
4. Install the torsion bar cover plate.
1. Position the cover plate.
