Ranger 4WD L4-2.3L VIN D (2002)
2. Install the transmission fluid filter screw.
6. Install the transmission fluid pan.
1. Position a new transmission fluid pan gasket on the transmission fluid pan.
2. Align and install the transmission fluid pan.
-
Loosely install the transmission fluid pan screws.
7. Tighten the transmission fluid pan screws.
-
Tighten the transmission fluid pan screws in a crisscross sequence.
8. Position the servo heat shield over the servos and clip it to the pan rail.
9. NOTE: If the vehicle was not equipped with a fluid filter, install a fluid filter kit. Follow the instructions supplied in the kit. If the vehicle was
equipped with a filter, install a new filter.
Install a new in-line transmission fluid filter kit or filter.
10. Lower the vehicle.
11. NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms can occur while the vehicle relearns its
adaptive strategy. The customer needs to be notified that they may experience slightly different upshifts either soft or firm and this is a temporary
condition and will eventually return to normal operating condition.
