Ranger 4WD L4-2.3L VIN D (2002)
Install the manual valve inner lever nut.
3. Rotate the manual lever into the NEUTRAL position, and install the manual valve detent spring.
4. Clean the extension housing and install a new extension housing gasket. Make sure that the parking pawl, spring, and shaft is correctly installed.
5. CAUTION: Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup. Install the extension housing.
1. Position the extension housing.
2. Install the extension housing screws.
3. Install the extension housing stud.
6. If equipped, install the transfer case.
7. NOTE: Align the drive shaft with the marks made during removal to ensure correct balance. Install the rear driveshaft bolts.
