Ranger 4WD L4-2.3L VIN D (2002)
NOTE: Inspect the counterbore of the extension housing for burrs. Remove any burrs from the extension housing counterbore with an oil stone.
Position the extension housing bushing into the extension housing.
2. CAUTION: The tool will bottom when bushing is in the correct position.
Using the special tool, install the extension housing bushing.
3. Position new extension housing seal with drain hole in the 6 o'clock position.
4. Using the special tool, install the extension housing seal.
5. NOTE: Inspect the driveshaft slip-yoke for wear and damage. Install a new component if required.
Align the driveshaft with the marks made during removal to ensure correct balance.
