Ranger 4WD L4-2.3L VIN D (2002)
5. Set the driveshaft assembled length to specification.
1. Remove any excess grease from the slip-yoke boot and driveshaft slip-yoke surfaces.
2. Position the slip-yoke boot in the slip-yoke boot groove.
3. Set the driveshaft assembled length to specification.
-
Measure from the stub shaft weld to the end of the driveshaft slip-yoke.
4. Bleed the air from the slip-yoke boot.
6. Using the special tool, crimp the large driveshaft slip-yoke boot clamp.