Ranger 4WD L4-2.3L VIN D (2002)
Axle Shaft: Service and Repair
Rear Drive Axle/Differential Ford 8.8-Inch Ring Gear
Axle Shaft
Removal
1. Raise and support the vehicle.
2. Remove the rear wheel and tire assembly.
3. Remove the brake drum.
4. Remove the differential housing cover and drain the lubricant.
5. Remove the differential pinion shaft.
1. Remove and discard the bolt.
2. Remove the differential pinion shaft.
6. CAUTION: Do not damage the rubber O-ring in the U-washer groove.
Remove the U-washer.
1. Push the axle shaft inboard.
2. Remove the U-washer.
7. CAUTION: Do not damage the wheel bearing oil seal.
Remove the axle shaft.
Installation
1. Lubricate the lip of the wheel bearing oil seal with grease.