Ranger 4WD L4-2.3L VIN D (2002)
Flex Plate: Service and Repair
Flexplate
Removal
1. Remove the transmission.
2. Remove the flexplate bolts.
Installation
1. NOTE:
-
Engine balancing is not required. Balance weights should not be installed on the new flywheel.
-
Special nuts are used for installation. Do not use standard nuts.
Install the flexplate. Tighten the nuts in the sequence shown in three stages:
-
Stage 1: Tighten to 50 Nm (37 ft. lbs.).
-
Stage 2: Tighten to 80 Nm (50 ft. lbs.).
-
Stage 3: Tighten to 112 Nm (83 ft. lbs.).
2. Install the transmission.
