Ranger 4WD V6-171 2.8L (1983)
Caliper Pin - Bolt Head On Outside
If the bolt head is on the outside of the caliper, use the following procedure:
Separation Between Bolt Head And Caliper Pin
^
From the inner side of the caliper, tap the bolt within the caliper pin until the bolt head on the outer side of the caliper shows a separation
between the bolt head and the caliper pin.
^
Using a hacksaw or bolt cutter, remove the bolt head from the bolt.
^
Depress the tab on the bolt head end of the upper caliper pin with a screwdriver, while tapping on the pin with a hammer. Continue tapping
until the tab is depressed by the v-slot.
^
Place one end of a punch (1/2 inch or smaller) against the end of the caliper pin and drive the caliper pin out of the caliper toward the inside of
the vehicle. Do not use a screwdriver or other edged tool to help drive out the caliper pin as the v-grooves may be damaged.
Caliper Pin Installation - Nut On Outside
