Ranger 4WD V6-171 2.8L (1983)
Ignition Lock: Service and Repair
Lock Cylinder Housing
Removal
1.
Remove steering column assembly from vehicle.
2.
Remove turn signal and wiper/washer switch from steering column.
3.
Remove upper and lower steering shaft bearings on non-tilt column, or lower bearing only on tilt column.
4.
Remove 2 bolts securing lock cylinder housing to outer tube flange. Rotate ignition key to ``Start'' position, then pull actuator interlock out of tube
clearance hole.
5.
Remove ignition lock drive and actuator.
Installation
1.
Install actuator and ignition lock drive gear.
2.
Turn ignition key to ``Start'' position to locate actuator interlock through outer tube clearance hole. Install, then torque lock cylinder housing
attaching bolts to 12---21 ft. lbs.
3.
Install upper and lower steering shaft bearings.
4.
Install turn signal and wiper/washer switch onto steering column.
5.
Install steering column into vehicle.
