Ranger 4WD V6-182 3.0L (1994)
6.
Disconnect the C105 bulkhead connector located in the LH rear of the engine compartment on the safety wall, Figure 7.
a.
Locate Circuit # 11 (T/Y), Figure 8.
b.
Remove it from the connector and tape it back to the existing harness.
7.
Insert the long thin terminal (round) from the RFI Suppression Audio Cable (F47Z-14A411-B) and insert it into the Circuit # 11 slot of the C105
(53) connector, Figure 7.
a.
Ensure it is fully seated.
b.
Reinstall the connector.