Ranger 4WD V6-182 3.0L (1994)
4. When completed, safety belt should look like the following.
Seat Belt With Anchor Plate Thread Damage
1. Remove the broken or stripped bolt and discard.
2. Drill out the internal threads in the safety belt anchor plate with a 27/64-inch drill.
3. Rethread the anchor plate with a 1/2-13 tap (seat belt).
4. Blow out the chips.
5. Install the attachment parts in the order shown, whichever is applicable. Tighten the replacement bolt to 30-40 N.m (22-30 ft-lb). Original parts
are to be replaced with the repair parts. Unless specified in the guides, use original parts.
6. When repairing a multiple belt and attachment, install nut to the bolt in the tunnel area from the underside of the floorpan. Tighten to specification
30-40 N.m (22-30 ft-lb).
Seat Belt Without Anchor Plate Thread Damage
1. Remove the damaged bolt for the anchor reinforcement and discard.
2. Install a new bolt with the same part number as indicated under Specifications. Tighten to 30-40 N.m (22-30 ft-lb).
