Ranger 4WD V6-183 3.0L (1993)
Child Restraint: Service and Repair
Installation
WARNING: The locking clip must be used to secure a child seat when your vehicle has a shoulder and lap belt with a sliding tongue. Every
seat belt that requires a looking clip is identified on the belt, with the label as shown. The locking clip is installed on a sample piece of webbing
to show proper installation.If you do not use a locking clip, injuries could result from the child seat tipping over during normal vehicle braking
or cornering.
1. Thread the belt webbing through the child seat according to the child seat manufacturer's instructions.
2. Buckle seat belt.
3. Pull on shoulder portion of the belt to make the lap portion fit snugly. keeping the lap belt snug, hold the lap and shoulder belt portions of the
webbing together next to the slip tongue and unbuckle the seat belt.
4. Slide either corner of the locking clip slot closest to the tongue over both layers of webbing.
