Ranger 4WD V6-183 3.0L (1993)
b.
While holding the caliper in place against the bottom pin rails, Figure 1, measure the clearance between the caliper and the top pin rails.
Clearance should be a minimum of 0.3B mm (0.015").
c.
If the clearance is insufficient, replace the caliper and measure again. If clearance concern still exists, replace the knuckle.
NOTE:
CHECK THE CLEARANCE ON THE NEW KNUCKLE BEFORE INSTALLATION.
d.
After measuring the caliper/knuckle for proper clearances, remove both calipers and inner pad assemblies.
e.
Remove the anti-rattle clip from the inner pad.
f.
Reinstall pad and check the side and end clearances with a feeler gauge (Figure 2).
