Ranger 4WD V6-183 3.0L (1993)
Individual components are not available for service. Therefore, if inspection determines component replacement, the entire CV joint must be replaced as
an assembly.
1.
Install inner bearing race in bearing cage with counterbore facing large end of cage.
2.
Push race to top of cage, then rotate race until ball slots are aligned with windows. This will lock race to top of cage.
3.
Install ball bearings.
4.
If removed, install dust boot on shaft using a new clamp.
5.
Install inner bearing assembly on shaft, then the circlip.
6.
Install spring and cap in outer bearing retainer and flange, then fill outer bearing retainer with suitable grease.
7.
Install inner race and shaft assembly in the outer bearing retainer and flange, then push inner race down and install wire ring.
8.
Fill top of outer bearing retainer with suitable grease. Remove excess grease from external surfaces.
9.
Pull dust boot over retainer until boot is seated in groove. Insert a suitable screwdriver blade between boot and outer bearing retainer to
allow trapped air to escape from boot.
10.
Install shroud over boot and retainer, then clamp in position.
