Ranger 4WD V6-183 3.0L (1993)
Shift Fork: Testing and Inspection
UNDER 8500 GVW - WITH M5OD, 5-SPEED
INSPECTION
Checking Shift Fork Hub Sleeve
1. Check contact surface of shift fork and clutch hub sleeve for evidence of wear or damage. Measure from shift fork to clutch hub sleeve. Clearance
should be 0.031 inch.
2. Check operation of clutch hub sleeve while assembled to hub.
3. Position clutch hub sleeve horizontally, then lift hub approximately 3/4 of the way off the sleeve and release. Hub should slide downward into
sleeve on its own. If necessary to push hub into sleeve, service as necessary.