Ranger 4WD V6-245 4.0L (1991)
Crankshaft Position Sensor: Service and Repair
Variable Reluctance (Crankshaft Position) Sensor
REMOVAL:
1.
Disconnect the negative battery cable.
2.
Disconnect the sensor electrical connector from the wiring harness.
3.
Remove the Variable Reluctance (Crankshaft Position) Sensor mounting bolts and remove the sensor.
INSTALLATION:
1.
Position the Variable Reluctance (Crankshaft Position) Sensor assembly on the engine.
2.
Install the two sensor attaching bolts and tighten to specified torque. (SEE SPECIFICATIONS/MECHANICAL)
3.
Route the sensor wiring harness and connect the electrical connector to the sensor.
4.
Connect the negative battery cable.
