Ranger 4WD V6-245 4.0L VIN X SFI (1999)
3. Install short brake tubes with the ends bent into the brake master cylinder reservoir.
-
Fill the brake master cylinder reservoir with High Performance DOT 3 Brake Fluid C6AZ-19542-AB or DOT 3 equivalent meeting Ford
specification ESA-M6C25-A.
4. For a new brake master cylinder, remove the cruise switch.
5. Fill the cruise switch with the specified brake fluid.
6. Install the cruise switch.
7. Slowly depress the primary piston or, for in-vehicle priming, have an assistant slowly pump the brake pedal until clear brake fluid flows from both
brake tubes with no air bubbles.
8. If necessary, install the brake master cylinder into the vehicle.
