Ranger 4WD V6-245 4.0L VIN X SFI (1999)
15. Connect one end of a flexible tube to the master cylinder bleeder screw. Submerge the other end in a container partially filled with the specified
brake fluid.
16. Have an assistant pump and then hold firm pressure on the brake pedal.
17. NOTE: Refill the brake master cylinder reservoir as necessary.
Loosen the master cylinder bleeder screw until brake fluid flows out of the drain tube.
18. Tighten the master cylinder bleeder screw.
19. Repeat the above three steps until there are no air bubbles in the expelled brake fluid.
20. Bleed the brake system.
Removal and Installation
Removal
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink
water and induce vomiting. Get medical attention immediately.
1. Disconnect the brake fluid level warning switch.
