Ranger 4WD V6-245 4.0L VIN X SFI (1999)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Hydraulic Assembly
Removal
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running waiter for 15 minutes. Get medical attention if irritation persists. If taken internally, drink
water and induce vomiting. Get medical attention immediately.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately
wash it with water.
1. Disconnect the battery ground cable.
2. Disconnect the electrical connector by lifting up on the release tab.
3. Disconnect the brake lines from the Hydraulic Control Unit (HCU).
4. Remove the HCU.
1
Remove the bolts.
2
Remove the HCU.
5. If necessary, remove the anti-lock brake control module.
Installation
