Ranger 4WD V6-245 4.0L VIN X SFI (1999)
Camshaft Position Sensor: Service and Repair
Camshaft Position (CMP) Sensor
Removal
1. Disconnect the battery ground cable.
2. Disconnect the connector from the Camshaft Position (CMP) sensor.
3. Remove the screws and the camshaft position sensor.
Note: If the synchronizer is turned while removing the CMP sensor, it must be re-aligned before the CMP sensor is installed. For more
information, refer to Synchronizer. See: Synchronizer
Installation
1. Follow the removal procedure in reverse order.
