Ranger 4WD V6-245 4.0L VIN X SFI (1999)
Special Tool(s)
1. Remove the rear door trim panel.
2. Use the 1/2-inch drill provided in D-Ring installation Kit to drill out the damaged threads in the upper pillar structure.
3. Apply a suitable lubricant to the M14 x 1.5 tap provided in D-Ring installation Kit and tap new threads.
NOTE: After each rotation, back off tap slightly to remove new cuttings and be sure to blow out any chips before proceeding.
4. Use a threaded insert provided in D-Ring installation Kit and screw it into the retapped hole until it is slightly below the surface.
5. Use a hammer to lightly tap the installation tool provided in D-Ring Installation Kit several times to seat the insert keys.
NOTE: If the two bolts on the height adjuster are not stripped, install the height adjuster. If the bolts are stripped, replace the height adjuster.
6. Install the rear door trim panel.
-
Check for normal operation.
