Ranger 4WD V6-245 4.0L VIN X SFI (1999)
7. Disconnect the tie-rod ends.
1
Remove and discard the cotter pins.
2
Remove the castellated nuts.
3
Disconnect the tie-rod ends from the steering knuckles.
-
Do not damage the tie-rod end boot seals.
8. Remove the LH tie-rod end. Count and record the number of turns required to remove the tie-rod end.
9. Remove the front stabilizer bar.
-
Note or mark the driver side end of the sway bar for correct installation.
10. Remove the power steering fluid cooler to crossmember nuts.
11. Remove the power steering fluid cooler.
1
Separate the power steering fluid return line hose from the power steering fluid cooler.
-
Allow the system to drain.
2
Disconnect the power steering return hose.
