Ranger 4WD V6-245 4.0L VIN X SFI (1999)
6. Remove the low/reverse band servo piston and rod and the low/reverse band servo piston return spring.
Installation
1. Clean and inspect the low/reverse band servo piston bore and the low/reverse band servo piston and rod.
2. NOTE: An A4LD Low/Reverse Servo band Return Spring D4ZZ-71031-A is to be used only as a test spring.
Install the low/reverse band servo piston and rod into the servo bore along with a low/reverse band servo return spring.
3. Install Servo Rod Selecting gauge.
1
Install a new low/reverse band servo separator plate cover gasket.
2
Tighten the three screws.
4. Tighten the servo gauge adjusting screw.
