Ranger 4WD V6-245 4.0L VIN X SFI (1999)
10. NOTE: Apply petroleum jelly on the valve body separator plate to hold the main control to separator plate gasket in place.
NOTE: Use new separator plate main control to separator plate gasket on installation.
Install the main control valve body separator plate and gasket to the main control.
1
Position the main control valve body separator plate to the main control gasket and install separator plate to main control valve body.
2
Install, do not tighten, the (3) screws.
11. Install the Guide Pins into the main control valve body.
1
Install large guide pin (.248).
2
Install small guide pin (.235).
12. Tighten the screws.
13. NOTE: Apply petroleum jelly on the separator plate surface to hold the gasket in place.
NOTE: Use new separator plate gasket on installation.
Install new main control to case gasket.
