Ranger 4WD V6-3.0L (2008)
13. Disconnect the outboard seat back latch release cable end.
1
Detach the cable from its anchor point.
2
Swivel the cable end and remove from the latch retainer.
3
Position the cable aside.
14. Disconnect the inboard seat back latch release cable end.
1
Detach the cable from its anchor point.
2
Swivel the cable end and remove from the latch retainer.
3
Position the cable aside.
15. Remove the 2 inboard seat backrest-to-cushion bolts.
16. Remove the 2 outboard seat backrest-to-cushion bolts.
17. NOTE: If equipped, note position of the lumbar cable where it comes through the seat cushion.
Remove the backrest assembly.
Installation
All seats
1. Install the backrest assembly.
2. Install the 2 outboard seat backrest-to-cushion bolts.
-
Tighten to 25 Nm (18 lb-ft).
3. Install the 2 inboard seat backrest-to-cushion bolts.
-
Tighten to 25 Nm (18 lb-ft).
4. Install the inboard seat backrest latch release cable.
