Ranger 4WD V6-3.0L (2008)
Part 2
Disassembly
WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure
to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which
increases the risk of serious personal injury or death.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
1. Remove the affected seat.
2. Remove the armrest.
3. Remove the backrest assembly.
4. Remove the seat track.
5. Remove the 2 screws and seat track position sensor from the seat track.
6. Release the remaining trim cover J-clips.
7. NOTE: Note the routing of the seat back latch release cable through the seat cushion frame.
Release the pin-type retainer and remove the seat backrest latch release cable.
