Ranger 4WD V6-3.0L (2008)
Wheel Cylinder: Removal and Replacement
Wheel Cylinder
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
1. Remove the brake shoes and linings.
2. Disconnect the brake tube-to-wheel cylinder fitting.
^
To install, tighten to 18 Nm (13 lb-ft).
3. Remove the 2 wheel cylinder bolts and the wheel cylinder.
^
To install, tighten to 15 Nm (11 lb-ft).
