Ranger 4WD V6-3.0L (2008)
6. Remove the nut and position the bracket aside.
-
To install, tighten to 12 Nm (9 lb-ft).
7. Remove the compressor manifold and tube assembly bracket nut.
-
To install, tighten to 12 Nm (9 lb-ft).
8. Loosen the A/C compressor manifold bolt and remove the compressor manifold and tube assembly.
-
Discard the O-ring seals.
-
To install, tighten to 20 Nm (15 lb-ft).
9. To install, reverse the removal procedure.
-
Install new O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
10. Evacuate, leak test and charge the refrigerant system.
