Ranger 4WD V6-3.0L (2008)
Remove the shift solenoids.
1
Remove the wire harness.
2
Remove the solenoid clamp screws.
3
Remove the solenoid clamp.
4
Remove the appropriate solenoid(s).
Installation
1. Install the new solenoid(s).
2. NOTE: The solenoid clamp must be installed in the torque converter clutch (TCC) and electronic pressure control (EPC) solenoid grooves, shift
solenoid pockets and the No. 204 plug.
Install the solenoid clamp.
1
Position the solenoid clamp on the main control valve body.
2
Install the solenoid clamp screws.
3. Connect the 6 solenoid electrical connectors.
1
Connect shift solenoid SSA, SSB, SSC, SSD electrical connectors.
2
Connect the TCC solenoid electrical connector.
3
Connect the EPC solenoid electrical connector.
