Ranger 4WD V6-3.0L (2008)
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
All vehicles
1. Carry out the steps necessary to prepare for programmable module installation (PMI).
2. Depower the SRS.
Vehicles with high-series floor console
3. Remove the floor console.
Vehicles with a consolette
4. Remove the consolette tray mat.
5. Remove the 4 screws and remove the consolette tray.
All vehicles
6. Disconnect the small RCM electrical connector.
7. Disconnect the large RCM electrical connector.
1
Pinch the thumb tab and pivot the connector position assurance lever all the way back until it stops.
2
Pull out and disconnect the RCM electrical connector.
8. Remove the 3 bolts and the RCM.
Installation
All vehicles
1. WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque.
Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
Install the RCM and the 3 bolts.
-
To install, tighten to 12 Nm (9 lb-ft).
2. Make sure the large RCM connector position assurance lever is in the full release position before attempting to connect the connector.
3. CAUTION: Putting the large restraints control module (RCM) electrical wiring connector into the RCM on an angle can cause bad
electrical connections and damage components.
