Ranger 4WD V6-3.0L (2008)
9. Release the pressure sensor bracket retainer and slide the pressure sensor off the bracket.
10. Remove the OCSM.
1
Remove the 2 screws from the OCSM.
2
Release the OCSM bracket retainer and slide the OCSM off the bracket.
11. CAUTION: A production occupant classification sensor (OCS) system bladder is shown. An OCS system service kit will have the OCS
system bladder attached to the seat cushion foam pad. Do not separate the OCS system bladder from the seat cushion foam pad. Failure
to do so can result in component failure.
Release the 3 OCS system bladder pin-type retainers from the seat cushion frame.
12. NOTE: Note position of wire routing for installation.
Route the OCS system bladder hose and pressure sensor, OCSM and seat wiring harness out through the seat cushion pan opening.
Installation