Ranger 4WD V6-3.0L (2008)
Front Steering Knuckle: Service and Repair
Wheel Knuckle
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may
result in major service expense. New parts must be installed with the same part number or an equivalent part if replacement is necessary. Do
not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of
correct retention of these parts.
1. Remove the wheel bearing and wheel hub.
2. Remove the wheel speed sensor harness bolt.
^
To install, tighten to 15 Nm (11 lb-ft).
3. Remove the outer tie-rod end nut.
^
To install, tighten to 80 Nm (59 lb-ft).
^
Install a new cotter pin.
4. CAUTION: Do not use a hammer to separate the outer tie-rod end from the wheel knuckle or damage to the wheel knuckle will result.
