Ranger 4WD V6-3.0L (2008)
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may
result in major service expense. New parts must be installed with the same part number or an equivalent part if replacement is necessary. Do
not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of
correct retention of these parts.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the torsion bar cover plate bolts and the torsion bar cover plate.
^
To install, tighten to 55 Nm (41 lb-ft).
3. NOTE: Before relieving the torsion bar tension, measure and record the measurement of the torsion bar adjustment bolt. This measurement will
be used as the preset depth for the new torsion bar adjustment bolt during installation.
Make preliminary adjustment references.
