Ranger 4WD V6-3.0L (2008)
Removal
1. Remove the axle shaft.
2. NOTE: If only a new seal needs to be installed, use care to avoid damaging the seal bore.
Using a suitable seal remover, remove the axle shaft oil seal. Discard the oil seal.
3. Inspect the rear wheel bearing and axle shaft for wear or damage.
4. If necessary, using the special tools, remove the rear wheel bearing.
Installation
1. Lubricate the new rear wheel bearing with rear axle lubricant.
2. Using the special tools, install the rear wheel bearing.
