Ranger 4WD V6-3.0L (2008)
6. NOTE: The outboard CV joint is not removable from the halfshaft. The boot must be removed or installed from the inboard CV joint side of the
shaft.
For the outboard CV joint, carry out the following:
1
Remove and discard the 2 boot clamps.
2
Remove and discard the boot.
Assembly
1. Lubricate the outboard CV joint.
1
Pack the outboard CV joint with grease from the kit.
^
One-third of the grease must be installed in the joint with the remainder placed in the boot.
2
Spread the remaining grease evenly inside the boot.
2. Position the boot so the rib on the boot is located in the groove of the shaft.
3. Position the outboard halfshaft boot and the outboard boot clamps.
1
Position the boot.
2
Position the 2 boot clamps.
