Ranger 4WD V6-3.0L VIN U (1997)
Keyless Entry Receiver: Service and Repair
Regular Cab
REMOVAL and INSTALLATION
1. Remove interior trim panel at the middle of the driver's "B" pillar.
2. Remove the two retaining screws for the bracket.
3. Remove the bracket from the module by lifting on the module plastic tabs which lock into holes on the bracket fingers.
4. Disconnect two connectors and the antenna plug.
NOTE: If the module is to be reinstalled, disconnect the smaller 22-pin connector. If the larger 26-pin connector is disconnected first, the module
will register an ignition tamper and will trigger the alarm when the wiring is reconnected.
5. To install, reverse removal procedure.
